How to deal with burrs on titanium machined parts? This kind of mechanical disposal method is: bury the titanium material in a lot of abrasives, add some grinding and polishing compounds dissolved in water, use the principle of oscillation to mix the abrasives with the material, and continuously ask the workpiece to scour, the surface and the edge of the workpiece. The corners are ground by abrasives and then polished. This technology can be used for deburring, chamfering, rust removal, descaling, flattening and fine polishing, and is suitable for various sizes and shapes of metal parts.

Abrasives can be alumina (including melted, sintered or natural), corundum, plastic, quartz, ceramics, etc., and can be a single species or a mixture of several. The shapes of these abrasives can be made into diangular, cylindrical, diamond-shaped, etc. The reason why they are first made into pre-formed abrasives is that they are more economical than materials of arbitrary shapes and natural shapes, and have a faster abrasion speed. According to the shape and size of the workpiece, choose different shapes and sizes of abrasives. Abrasives for rolling include pumice, quartz, granite skin angles, shells, iron filings and ceramic fragments. The size of the abrasive particles should be larger or smaller than each hole of the part. The amount of content in the drum is also an important factor affecting the quality of the agricultural surface of the parts. The amount of people inside the drum is usually 70% of the drum volume. The solution in the drum should be added to about 95% of the drum volume (note: when adding acidic solution to the drum, you should add enough water first, and then add acid to avoid corrosion of parts during the tumbling process, because of the increase in time. , The concentration of the inner solution gradually decreases, and even loses its effect.
The processing time can be from a few minutes to a few hours. The key is to choos